Tuesday, May 28, 2013

Amazing Fel-Pro MS98006T Intake Manifold Gasket Se


Product Description

Intake Manifold Set


  • Fel-Pro MS98006T Intake Manifold Gasket Se
  • Genuine Fel-Pro Part

Fel-Pro MS98006T Intake Manifold Gasket Se Reviews


Amazon.com
Customer Reviews
Average Customer Review
1 Review
5 star:
 (1)
4 star:    (0)
3 star:    (0)
2 star:    (0)
1 star:    (0)
 
 
 

1 of 1 people found the following review helpful
5.0 out of 5 stars FelPro Torque specs are higher than factory, July 3, 2010
By 
TiVoNOT (FL United States) - See all my reviews
Amazon Verified Purchase( What's this?)
This review is from: Fel-Pro MS98006T Intake Manifold Gasket Se (Automotive)
This kit contains everything you need to complete a full upper and lower intake manifold gasket replacement on a Ford 2000 4.0L OHV V6. Be careful when torqueing down the new gaskets, following the order in the factory manual but using the torque settings from the FelPro kit's insert. This is important because the factory used a different, one piece style of lower gasket and the FelPro uses a superior two piece design. These engines are very prone to intake gasket leaks from the factory and the FelPro two piece design is an attempt to correct this. Since the gasket design is different the torque specs are as well so save that little piece of paper from the kit and use those specs, not the factory's. Also note that you will need the tube of RTV supplied in the kit to complete the lower manifold gasket seal to the block in front and back.

After install this solved my Bank1 and Bank2 Lean condition and turned off the Check Engine Lamp.
Help other customers find the most helpful reviews 
Was this review helpful to you?  Yes No


Share your thoughts with other customers:
  See the customer review...

No comments:

Post a Comment